Profibus

NAVIGATION: Field buses > Profibus

The implementation in the controller is based on the PROFIdrive profile version 4.0.

Data transmission using two-wire twisted pair cable (EIA 485)
Transmission as differential signal
Transfer rate: max. 12 MBaud
Device definition via GSD file (device master file)
Automatic baud rate detection
PROFIBUS address can be set using the rotary coding switches or alternatively using the addressing parameters
Cyclic data exchange reference and actual values using DPV0
Acyclic data exchange using DPV1
Synchronization of all connected drives using freeze mode and sync mode
Reading and writing drive parameters using the PKW channel or DPV1
Termination with terminating resistor (220 Ohm) at bus-end
Master/slave system

NOTE:

For a detailed description of the PROFIBUS field bus system refer to the separate "Profibus User Manual".