Technische Daten

NAVIGATION: encoder > X8_(Option_Channel3) > TTL_Encoder simulation > Technical data

Technical data

TTL signal evaluation

	Specification
Interface	Differential voltage input, RS422-compatible; pay attention to voltage range! Max. cable length: 10 m Connector: 15-pin D-SUB, High-Density, female Wave terminating resistor built-in to device: 120 Ω
	Min.	Max.
Input frequency	0 Hz	500 kHz
Input voltage
Differential switching level "High"	+0.1 V
Differential switching level "Low"		-0.1 V
Signal level referred to ground	0 V	+5 V

Tabelle: TTL encoder input on X8

TTL encoder simulation

	Specification
Interface	RS422-compliant Electrically isolated from the drive controller Connector: 15-pin D-SUB, High-Density, female
	Min.	Max.
Output frequency	0 Hz	1000 kHz
Output voltage
Signal level referred to ground	0 V	+5 V
Differential output voltage \|U\|	2.0 V	5.0 V	Wave terminating resistance ≥ 100 Ω

Tabelle: TTL encoder simulation on X8

Voltage supply to external encoder

	Specification
	Min.	Max.
Output voltage	+ 4.75 V	+ 5.25 V	+5 V
Output current		250 mA

Tabelle: Voltage supply for external encoders on X8

NOTE:

No provision is made for connection of sensor cables to compensate for the voltage drop. So the chosen supply cable cross-section should take account of the voltage drop.

NOTE:

The encoder supply on X8/3 is short-circuit-proof.